Knife Blade Damascus Bar 12 1/4" x 2 3/8". This damascus steel is in the
annealed (soft) state so you can cut, drill, and grind it with normal
metal working tools and equipment. After working the blade it must be
heat treated (hardened and tempered). It must then be etched to bring
out the pattern of the Damascus. Etch in Muriatic Acid from the local
hardware store. BE SURE TO FOLLOW LABEL SAFETY DIRECTIONS! Be sure the
steel is clean! Etch time varies. Start with 5 minutes, then wipe and
repeat until desired etch depth is reached. After etching you must
neutralize the acid by rubbing the blade with a paste made from baking
soda and water. Dry and oil immediately. |